Skip to content

DPCAV

SHUTTERBUG PRO

Photography ExampleClick Me!
Installation ManualClick Me!
ShutterBug Pro is a tiny accessory that helps take digital ...

DPCAV

SERVO Y-CABLE, DELUXE

Data SheetNot Available.
These servo Y-cables have two female servo receptacles on one ...

DPCAV

SERVO SIGNAL BOOSTER-AMP

Weight1.5 grams.
Current Draw2mA typical.
SizeStandard servo cable.
Wire Length12 inches (30cm).
ConnectorsUniversal JR/Hitec style R/C connectors.

Instructions:,

This Servo Signal Booster is used to restore the low ...

DPCAV

HITEC HS-65HB SERVO

Data SheetClick Me!
The Hitec HS-65HB R/C servo is recommended for our Pandora ...

DPCAV

HITEC HS-81 MICRO SERVO

Data SheetClick Me!
The Hitec HS-81 micro R/C servo is recommended for our ...

DPCAV

E-SKY SERVO ADJUSTER / TESTER

Features:,

The E-Sky Servo Tester is a low cost servo signal ...

DPCAV

SELF GRIP VELCRO STRAP

,

This Velcro type strap material wraps around anything and sticks ...

DPCAV

PROTECTIVE FOAM RUBBER PAD

,

These soft rubber pads are normally used to protect model ...

DPCAV

R/C CONTROLLED ON-OFF SWITCH

Weight7 grams.
Operating Voltage5VDC max, powered by R/C receiver.
Switched OutputTransistorized type, 30V / 10A max rating.
CompatibilityMost R/C receivers (Failsafe requires PPM Rx).
Servo CableUniversal R/C type, 6 inches (150mm).
Switch CableSilicone wires, 3 inches (80mm).
InstructionsClick Me!

Notes: The failsafe feature is compatible with standard PPM receivers. It will be ignored if used with DSP, PCM, or Spread Spectrum R/C systems. Also, if the switched output is powered by a separate battery, a common ground connection is required to the R/C system's battery (details are in the instruction manual).,

Plug this electronic switch into any spare channel on your ...

DPCAV

1.3GHZ A/V RECEIVER WITH COMTECH TUNER

Four (4) RF channels1240MHz, 1280MHz, 1320MHz, 1360MHz.
Instruction ManualClick Me!

Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver..,

This 1.3GHz wireless A/V (audio/video) receiver is compatible with our ...

DPCAV

900MHZ ANTENNA, V-DIPOLE

Frequency Range880-980MHz
Gain~2dBi typical
Impedance~50 ohms
PolarizationLinear
RF Power10 watts maximum
ConnectorSMA Plug (male)
Size4.6 inches (115mm) tip-tip length
Weight13 grams
ColorGreen
InstructionsClick Me!

Cable Length:, 10 inches (250mm) long,

This lightweight V-Dipole style antenna is designed specifically for 900MHz ...

DPCAV

1.2GHZ - 1.3GHZ ANTENNA, V-DIPOLE

Frequency Range1240-1320 MHz
Gain~2dBi typical
Impedance~50 ohms
PolarizationLinear
RF Power10 watts maximum
ConnectorSMA Plug (male)
Size3.4 inches (87mm) tip-tip length
Weight13 grams
ColorGreen
InstructionsClick Me!

Cable Length:, 10 inches (250mm) long,

This lightweight V-Dipole style antenna is designed specifically for 1.2GHz ...

DPCAV

900MHZ A/V RECEIVER WITH COMTECH TUNER

Four (4) RF channels910MHz, 980MHz, 1010MHz, 1040MHz.
Instruction ManualClick Me!

The receiver requires a common 2.1mm barrel type DC power cord (available separately). We offer several different types and they can be found here:click here, half-wave dipole is a popular antenna choice and can be purchased with the receiver as an option. We offer other 900Mhz antennas too:click here., Important note: The DC input connector is a 2.1mm barrel style connector that is center (+) positive. Reversed voltages will damage the receiver.,

This 900MHz wireless A/V (audio/video) receiver is compatible with our ...

DPCAV

5.8GHZ A/V TRANSMITTER, 200MW

,

SOLD OUT: No longer available. This 5.8GHz / 200mW wireless ...

DPCAV

5.8GHZ CIRCULAR POLARIZED PATCH ANTENNA, +5DBI

NoteInstallations that require an RP-SMA connector will need adapter
Data sheetnot available.

5.8Ghz Patch Antenna: This four element Patch Array antenna has approximately 5dBi of gain, 45° beamwidth, and RHCP circular polarization. But don't let its low price fool you -- it is a very good performer. We've found that it is an excellent receiver antenna in 5.8GHz FPV installations that are using a, Important: Do NOT paint or directly apply any covering materials to the antenna. You may place it inside a plastic enclosure that is rated as microwave safe, but we recommend that the front side have at least two inches spacing from the plastic surfaces to avoid reducing the antenna's performance.,

Cloverleaf circularly polarized antenna on the transmitter. Try it -- ...

BevRC DPCAV Hobby-Lobby HobbyKing LowPriceRC ngHobbies NitroTek R2Hobbies RangeVideo RCTimer ReadyMadeRC HobbyWireless RCPlanet HorizonHobby HiModel OFM GetFPV AMainHobbies SDSHobby GoodLuckBuy Flying-Hobby